i-Crafter Tool, i-Mend Self-Mending Cutting Pad – 1pc

Works on GEMINI Machines too!

A self-mending cutting pad for your manual die cutting machine as well as the GEMINI! 

Cutting pad dimensions are 6 1/8" x 9" (15.32cm x 22.5cm). Sized to fit manual die cutting machines with a 6" wide opening. Sandwich heights may vary.

Place the i-Mend Self-Mending cutting pad on your machine cutting platform, place the material to be cut on top, place your die, blade side down, add one hard cutting deck on top and run this through your die cutting machine. No more cracking sounds as it runs through the machine.

• Flip and rotate the Decks as you work especially if you are doing large quantities of die cutting.
• Start by using the least amount of pressure. Begin with the basic sandwich required per the machine manufacturer's instructions.
• If you still need more pressure, add a shim and repeat with up to three passes.
• Note: for intricate dies, we recommend our hard, translucent cutting deck.
• Avoid exposing the i-Mend Deck to heat.

Our self-mending cuttingpad heals itself and cuts smoothly. Clean the i-Mend pad with cold water and gentle scrubbing to remove small bits of paper left behind.

Flip and rotate the Decks as you work especially if you are doing large quantities of die cutting.

• Start by using the least amount of pressure. Begin with the basic sandwich required per the machine manufacturer’s instructions.
• If you still need more pressure, add a shim and repeat with up to three passes.
• Note: for intricate dies, we recommend our hard, translucent cutting deck.
• Avoid exposing the i-Mend Deck to heat.

Our self-mending cutting deck heals itself and cuts smoothly. Clean the i-Mend Deck with cold water and gentle scrubbing to remove small bits of paper left behind.